...the wash results are not satisfactory
The dishes are not clean
IThe wrong washing programme has been selected.
IThe dishes were arranged in such a way as to stop water reaching all parts of the surface. The baskets must not be overloaded.
IThe spray arms do not rotate freely due to wrong arrangement of the load.
IThe filters in the base of the washing compartment are dirty or incorrectly positioned.
IToo little or no detergent has been used.
IWhere there are limescales deposits on the dishes; the salt container is empty or the wrong level of the water softener has been
selected.
IThe drain hose connection is not correct.
IThe salt container cap is not properly closed.
The dishes are wet and dull
IRinse aid was not used.
IThe rinse aid dispenser is empty.
There are streaks, milky spots or a bluish coating on glasses and dishes
IDecrease rinse aid dosing.
Water drops have dried onto glasses and dishes
IIncrease rinse aid dosing.
IThe detergent may be the cause. Contact the detergent manufacturer?s consumer care line.
If after all these checks, the problem persists, contact your
local Service Force Centre, quoting the model (Mod.), product
number (PNC) and serial number (S.N.).
This information can be found on the rating plate located on
the side of the dishwasher door (see picture).
So that you always have
these numbers at hand, we
recommend you to make a
note of them here:
Mod. : . . . . . . . . . . . . . . . . . .
PNC : . . . . . . . . . . . . . . . . . .
S.N. : . . . . . . . . . . . . . . . . . .
RA08
14 |
ACEC
